The quality of the LED light lines must be the same, no yellow light or other light colors appear. If you don't know how to distinguish, you can teach everyone a small method. Only by lighting these lights and observing their light color changes, you can get the desired answer. Due to the high brightness of the LED line lamp, the same type of lamp of the two brands, under the same conditions, using the direct eye observation method to compare and compare, it is difficult to judge the brightness of the level, and at the same time it is easy to damage the eyesight. Usually we recommend using a piece of white paper to cover the light source, and then attenuating the light by white paper, then compare it. It is easier to see the difference in brightness of the light. The higher the brightness, the better.

    Led line light can be controlled by built-in microchip. In small engineering applications, it can be used without controller. It can realize dynamic effects such as gradation, jump, color flicker, random flicker, gradual change, etc. It can also be controlled by DMX. Achieve chasing, scanning and other effects. It is convenient in terms of operation and application, which is one of the reasons why line lights are favored by more and more customers.

    The seal between the glass and the lamp shell, the led line lamp manufacturer does not recommend the glue. In addition to the ultra-slow production efficiency, the glue will also bring the problem of unsafe and unmaintainable waterproof. Once there is a small stick, it is not good. All are in a scrapped state. If the appearance is handled well enough, screwing directly from above is a good method in all respects. Of course, the more popular compact structure is more reasonable, except that the production efficiency is relatively slow. In addition, it is also necessary to pay attention to the size and hardness of the rubber ring. Too thick and too hard will bring assembly difficulty. If it is too thin, it will bring about the situation that the glass pressure is not tight. The hardness of the rubber ring is about 35.

    In fact, many people now do 90% of the correct work, but here will be the same, all aspects are done very well, the lights are like water, the problem is here, so here are the following suggestions: 1, glass, The beading and the three body of the lamp body must be flush. If it is unavoidable, it is not recommended that the flatness of the three is more than 0.5mm. 2. It is necessary to tap the screw hole of the end cover. It is not necessary to use self-tapping screws. The self-tapping screws will cause the end cover to be uneven during the pressing process. The screws use the inner 6-point screws of M4. The material is stainless steel, by the way. Remember to add a spring pad, the reason is not one by one. 3. The rubber ring should be fixed in the end cover. It is not recommended to use the flat end cover; the rubber ring should be wide enough, and the rubber ring should have at least 2mm width on both sides of the pressed surface to prevent the apron from being pressed. In the process, "running the road" causes water to enter, and of course the rubber ring can not be too hard. 4, after a ring of silicone on the rubber ring and then fixed, this seems to be cumbersome but very effective, to make up for the water inflow caused by unevenness of the end face due to various reasons, of course, the premise is that you can not use this rubber and aprons The reaction caused the glue to not dry,

    The led line lamp is mainly used for landscape pool, fountain, swimming pool, hydrophilic platform landscape decoration lighting, the shell is made of 304# stainless steel, the appearance is exquisite, stable and overall waterproof. Led line lamp is also known as underwater LED wall washer. The color is colorful and monochrome. It can illuminate the pool wall to achieve the overall decorative effect. The led line lamp adopts DC24V voltage, which belongs to CLASS III type lamps. It is safe and reliable, and has no safety hazards.